Hot Take: Why the Viral Four-Wedge Planing Stop Only Needs One Wedge

The Problem

When planing a thin board, it's hard to clamp it to your workbench. The jig that solves it has been circulating lately as four wedges — two glued to the bench, two loose inside them, joined with a strip of elastic or webbing — and it does work.

This creator's objection to that version is the part count and where it leaves the work: "it's actually totally stupid," and "it's terrible for your body. You need to be planing in close, not all the way out here."

What the Older Version Does Differently

Three pieces instead of four, and one of them slides.

  • A narrow fixed strip to plane against. Narrow is the part that matters: it holds the work near the front edge of the bench, where you plane with your arms in rather than extended.
  • One sliding wedge, where the viral version uses two.
  • A small block glued across the thin tip of that wedge. The block catches the end of the board, so the single wedge both tapers and hooks — which is the job the second loose wedge was doing. It grips any width of stock without being sized to it.

In use, the board goes against the strip and the wedge pushes up behind it. Planing away from you drives the wedge home; a tap backwards releases the work.

Pro tip: He gives no sizes, so treat the three pieces as proportions rather than a cut list: the wedge taper wants to be shallow enough to hold by friction, and the block only has to stand proud of the wedge by less than your thinnest stock, or the plane will hit it. Set the wedge so the cutting stroke tightens it — fitted the other way round, every pass loosens the work.
Pro tip: This is not a new design. He points out that the single-wedge version has been in trade manuals and journals for about a century, and that the four-wedge one is a recent reinvention of it.

DIYsolvr helps you find the best DIY videos. Browse all 609 techniques