Drive Screws in Straight Rows With a Marked Shim

The Problem

If you're driving a lot of screws in the same spot on board after board, eyeballing them leaves rows that wander.

The Technique

  1. Take a shim, or any thin scrap of wood.
  2. Mark your screw positions on it once, at the spacing you want.
  3. Hold the shim against the edge of each board, lined up the same way every time.
  4. Drive the screws at the marks, then move the shim to the next board.

DIYsolvr helps you find the best DIY videos. Browse all 609 techniques