Get Cable Around a Corner Inside a Stud by Stripping the Jacket

The Problem

Where a run has to change direction inside framing, the two drilled holes meet at a right angle inside the stud or the top plate. When you push the cable into the first hole it hits the far side of the timber and stops: there is no radius for it to follow, and nothing to grab from the other side because the end is still buried.

The Technique

  1. Drill the two holes so they intersect inside the timber — the hole the cable enters has to run past the second one, or there is no opening between them for the cable to turn into.
  2. Strip the outer jacket back off the end of the cable, leaving the individual conductors loose. Enough that the loose length can clear the second hole.
  3. Flex the loose conductors back on themselves so the end is limp and compact rather than a stiff flat ribbon.
  4. Feed that end into the entry hole and keep pushing past the point where the second hole breaks through.
  5. The loose conductors drop into the perpendicular hole as they pass it. Reach into that hole with needle-nose pliers, catch them, and pull the cable through.

Why Stripping the End Helps

The jacket holds the conductors flat and side by side, which makes it harder to turn a sharp corner. With the jacket off, each conductor bends on its own. The stripped end also gives the pliers something to bite that is narrower than the cable.

Safety note: Work dead — this is a rough-in technique and the circuit should not be energised. Strip only the jacket you will cut off anyway, keep the conductor insulation intact, and check the sheathing still runs into the box far enough to satisfy your local code after the pull.

Electrical, plumbing, and structural work may be regulated where you live — check local code before you start, and note that a permit may be required. More in our disclaimer.

DIYsolvr helps you find the best DIY videos. Browse all 609 techniques