Replace One Vinyl Plank Without Lifting the Floor

The Problem

If you gouge one plank in the middle of a click-together vinyl floor, there is no edge to lift and nothing to slide out — the planks hold each other down. Taking the floor apart back to the damage means pulling up every plank between the wall and the one you want.

The Technique

  1. Cut a triangle into the plank, corner to corner, then a straight line down the middle of what is left. Where the plank meets an end-joint on its short side, cut the triangle from that corner.
  2. Vacuum the cut before you lift anything. Grit left in the joint stops the new plank seating.
  3. Lift the pieces out. They come away without prying if the cuts are right.
  4. If there is a vapor barrier under the floor, tape it back up before the new plank goes down.
  5. Cut the new plank to fit the opening exactly.
  6. Trim the tongue off the new piece (see video). The plank then drops into the hole from above instead of angling in sideways.
  7. Check the fit dry before any glue goes near it.
  8. Glue it in at the edges only, where the new plank meets the planks around it. Superglue is what the source uses.
Pro tip: Glue the new plank's edges to the planks around it and nothing else, so the floor still floats as one piece. A bead that reaches the subfloor pins the floor at that point. A floating floor pinned in one spot buckles or gaps somewhere else as it moves with the seasons.
Safety note: Set the blade just deep enough to cut the plank. Underneath it are the underlayment, the vapor barrier, and in some floors heating pipes or cable, none of which you can see from above.

DIYsolvr helps you find the best DIY videos. Browse all 609 techniques