Stop an Adjustable Wrench Slipping by Pulling Toward Its Fixed Jaw

The Problem

If your adjustable wrench keeps slipping and rounding nuts, the direction you are turning it may be why. The tool has a fixed jaw forged into the head and a movable jaw riding on a worm screw. The two are not equally strong. When you push against the movable jaw, the load goes through the screw and the slide, where the flex and the slop are. The jaws open under load, the wrench slips, and the corners of the nut round off.

The Technique

  1. Set the wrench on the nut and find the fixed jaw — the one forged into the head, with no screw behind it.
  2. Turn the wrench over if you need to, so the fixed jaw is on the side of the handle you are going to pull toward.
  3. Run the worm screw until the jaws are snug on the nut with no play before you load it.
  4. Pull. Never push.

The rule in one line: pull on the same side of the wrench that carries the fixed jaw. On light work it will cope either way, so set it up the same way every time rather than only when you expect resistance.

Pro tip: Some adjustable wrenches carry an arrow stamped near the head showing the direction to pull. Many also have a handle made wider and flatter on the face you pull against, so the comfortable way to hold it is the correct way.

DIYsolvr helps you find the best DIY videos. Browse all 609 techniques