The Problem
If you are cutting a box into a finished wall, a stud finder only tells you where the studs are, not whether the box will fit.
The Technique
- Push a length of stiff solid wire into the wall where the box will go. By hand is usually enough; chuck it in a drill if the wall resists. If it goes in as deep as your box needs, the cavity is deep enough.
- Bend one end of the wire over, so the bent leg is half the width of the opening you intend to cut.
- Bend the other end over the same way.
- Push the bent wire into the probe hole and turn it, working it back and forth as you go. The leg inside the wall sweeps a circle as wide as your opening.
- If it strikes something, the box does not fit there. The outside leg points the same way as the one inside, so it tells you which side the obstruction is on.
- Move along the wall and probe again.
Safety note: You are putting a bare conductor into a cavity that may contain live cable. Nothing in this method finds cable before you touch it. Kill every circuit that could run through that wall at the panel first, and confirm dead at a nearby outlet. Gas and water lines share those cavities. A wire driven by a drill can damage one.
Electrical, plumbing, and structural work may be regulated where you live — check local code before you start, and note that a permit may be required. More in our disclaimer.