Wiring
Snug Up a Recessed Outlet With a Spacer Nut on the Mounting Screw
Threading a nut onto the mounting screw as a spacer to snug up a loose or recessed outlet.
@biewer_remodeling_ · Instagram
Technique: Outlet Terminals and Backstabbing
Some receptacles have two ways to accept the same wire, and they are not equivalent. One of them is faster, and it's the one that fails.
A standard 15-amp duplex receptacle has terminals that are colour-coded by function, and the colours are the whole convention:
The colour coding is not decorative. Hot and neutral are not interchangeable even though the lamp lights either way: reversed polarity puts the switched side of an appliance permanently live, so a lamp socket's shell is hot with the switch off.
The push-in hole takes a straight stripped wire — no loop, no screw, a second per connection instead of thirty. Almost every electrician avoids them, and the reason is mechanical rather than superstition.
A screw terminal clamps the conductor between two metal faces, under force supplied by the screw and maintained by it. The contact area is the width of the wire across the plate.
A backstab holds the wire against a small internal spring contact — a much smaller contact patch, held by spring tension alone.
Current through a joint heats it, and every appliance switching on and off cycles that heating. Metal expands and contracts. A clamped joint stays clamped through those cycles because the screw keeps loading it. A spring contact relaxes: each cycle makes it lose a little tension. Over time, contact resistance climbs, the joint heats more, and it gets worse from there. Eventually there can be arcing inside a closed box.
That's why a house full of backstabbed outlets is worth knowing about even if you never open one. If your cover plates feel warm or a circuit drops out under load — this might be your problem. It's a thing to have an electrician change while they're there for something else.
Electrical, plumbing, and structural work may be regulated where you live — check local code before you start, and note that a permit may be required. More in our disclaimer.
DIYsolvr helps you find the best DIY videos. Browse all 609 techniques