Cut a Vent in the Caulk Tube's Plunger to Stop the Endless Ooze

The Problem

You release the caulk gun's trigger, the pressure should stop — and the tube keeps oozing anyway, laying an unwanted bead while you move to the next spot. It isn't your gun's plunger still pushing. When a trim carpenter finally called the manufacturer about it, the answer was trapped air: an air bubble or two gets sealed into some tubes at the factory, and once compressed, that air keeps pushing caulk out long after you've let off.

The Technique

Vent the air instead of fighting it:

1. Before loading the tube, cut a small X — or a little triangle — into the plastic plunger cup in the bottom of the tube.
2. Load and caulk as normal.

The cut is small enough that the gun's plunger still drives the tube's plunger forward normally, but trapped air escapes through it instead of storing pressure. Release the trigger and the bead actually stops. The installer behind this runs architectural molding full-time and calls it the fix that ended the mess on his jobs.