Edge a Gravel Path With Brick So the Gravel Stays Put and the Mower Clears It

The Problem

Gravel laid without an edge migrates into the lawn at the shoulders, and the lawn creeps back into the gravel. Within a season there is no clean boundary left.

Brick edging holds that boundary, and it has to be right on two counts. Brick that finishes above the lawn catches the mower deck. Brick that is level to its neighbour but drifts over the length of the run reads as a wobble from thirty feet away, which is the distance a path is usually seen from.

The Technique

Set the depth before you set a brick.

  1. Level and tamp the base. Crushed road base — class 5 or equivalent — in layers of 1 to 2 inches, tamping between every layer and checking for level as you go. A rented plate compactor does this faster; a hand tamper does it if you are willing to spend the time.
  2. Check the depth against a brick on edge, plus the sand bed, before you commit. You want the top of the finished brick to come up flush with the grass. Too high and the mower hits it; too low and the lawn grows over it. Leave an extra half inch to one inch of room for the sand bed in step 4.

Then set the bricks.

  1. Run landscape edging along the path to brace the bricks. Stiff sections handle a straight run. For a curve, clip the edging — the cuts let it bend to the radius without kinking.
  2. Bed the bricks in a half to one inch of coarse washed sand. The sand bed is what lets you move a brick a sixteenth of an inch without disturbing the base underneath, which is why the bricks don't go straight onto the compacted gravel.
  3. Level every brick individually and tap it down with a rubber mallet. Expect to put the level on each brick eight or ten times rather than once.

Then lock it in.

  1. Fill between the bricks with gravel and tamp it in. This is what stops the bricks moving, so do it before anything walks on them. Once the bricks are set, don't step on them.
  2. Sweep polymeric sand into the joints. It firms up the first time it gets rain or a sprinkler and adds stability the loose gravel can't.
  3. Spread the top coat of gravel and tamp it level with the top of the bricks. Flush is the target — gravel standing above the brick migrates over it.
Pro tip: The depth check in step 2 is the one that cannot be fixed later. Every other step here can be redone in an afternoon; a path whose bricks sit an inch proud means lifting the bricks, removing base material, and re-tamping the whole run.
Safety note: Polymeric sand is sharp silica dust until it is wet. Sweep it in with a respirator on, and keep the hose off it until the joints are filled and the excess is swept clear of the brick faces, or it sets as a haze on the brick.
Pro tip: This covers the edging and finishing. For the base underneath, building the path up in compacted layers is the same principle done with a plate compactor and no edging at all — worth reading alongside this, since the two takes disagree about whether a gravel path needs a hard edge.

What You'll Need

Crushed road base (class 5 or local equivalent), coarse washed sand, landscape edging with spikes, edging bricks, gravel for the joints and the top coat, and polymeric sand.

DIYsolvr helps you find the best DIY videos. Browse all 609 techniques