Prevent Pruning Damage by Undercutting the Limb Before Removing It

Take a heavy limb off in three cuts rather than one. An initial undercut lets the limb break away cleanly instead of peeling a strip of bark down the trunk.

bark peeled down the trunk, flush cut damage, how far from the trunk to prune, pruning stub died back, cutting a big branch safely

intermediate Tools: pruning saw Added Nov 2, 2026

The Problem

Two things go wrong when a limb comes off in a single cut. The weight of the limb tears a strip of bark down the trunk as it falls, opening a wound several times longer than the cut you made. And a cut taken flush against the trunk removes the branch collar — the swollen ring where the limb meets the trunk — which is the tissue the tree grows new wood from to close the wound. Take the collar off and the wound stays open.

(The third failure is picking the wrong place to cut — if you shorten a branch back to a bare stub, the stub will die back because nothing is left on it to draw growth. If you want to reduce a branch rather than lose the whole thing, cut it back to a lateral branch instead of to a nub. The lateral needs to be at least one third the diameter of the branch you are cutting back to it. Below that it cannot support the growth, and the stub above it dies anyway.)

The Technique

Take the weight off in three cuts

Work out from the trunk — a foot or so, not up against it.

  1. Undercut. Saw up into the underside of the limb, partway through.
  2. Overcut. Saw down from the top, slightly further out than the undercut, until the limb breaks away. Because the two cuts are offset, the limb hinges and snaps at the undercut rather than peeling.
  3. Final cut. With the weight on the ground, cut the remaining stub back to the collar. Find the branch bark ridge on the upper side and the swollen collar underneath. Cut just outside both of them, angling the cut slightly away from the trunk. Do not cut into the swelling itself — that is live trunk tissue, and cutting it is what turns a healed-over scar into a permanent hole.
Pro tip: The offset between the first two cuts is the part that does the work, so do not line them up. The overcut sitting a little further out than the undercut is what makes the limb break at a controlled point instead of running the tear into the trunk.
Safety note: A limb heavy enough to need three cuts is heavy enough to injure you on the way down. Work out of its fall path rather than under it, and know where it will land before you start the first cut. Anything above head height, anything you would need a ladder for, or anything near a power line is a job for someone with ropes and the training to use them.

DIYsolvr helps you find the best DIY videos. Browse all 609 techniques