Find the Root Flare Before You Plant a Tree

Don't bury the flare where the trunk widens into its roots.

planted tree too deep, new tree dying years later, where should the root ball sit, trunk flare buried, tree planting depth, roots growing out of the trunk

intermediate Tools: shovel, pruning shears Added Nov 9, 2026

The Problem

If you have planted a tree that looked fine for a few years and then went backwards, it may have been too deep in the hole. The usual instruction is to measure the root ball, dig to that depth, and set the tree slightly above grade. That works only if the top of the root ball is the top of the roots.

The Technique

  1. Before the tree goes anywhere near the hole, remove the soil off the top of the root ball. Work it back by hand, or with a shovel held almost flat.
  2. Keep going until you reach the flare. A buried flare can sit six inches or more below the top of the root ball.
  3. Cut off any roots growing out of the trunk above the flare. These are adventitious — the tree grew them into the heaped soil to reach nutrients — and once that soil is gone they dry out and die. Cut them close to the trunk.
  4. Measure from the flare down to the base of the root ball. That measurement, not the depth of the root ball as it arrived, is how deep the hole goes.
  5. Set the tree with the flare at grade or slightly above it, and backfill to there. The flare is the reference point, not the top of the root ball.
Pro tip: Uncover the flare while the tree is still out of the hole, where you can reach the root ball from all sides. Doing it after the tree is set and backfilled means digging it out again.

DIYsolvr helps you find the best DIY videos. Browse all 609 techniques