No-Stain Layout Lines
Snapping temporary layout lines that vanish instead of staining the finished surface.
Crown and Plane Deck Joists Level Before You Install Them
Clamp adjacent joists together and run a planer across their top edges so they sit level with each other once installed, instead of relying on crown alone.
wavy deck surface, humps in the deck, flatten joist tops, uneven floor framing
The Problem
Deck and floor joists rarely come out of the lumber stack perfectly straight — nearly every board has some crown, a slight bow along its length. Standard practice is to install each joist crown-up, but crown alone doesn't guarantee the tops line up with each other. Small differences between boards show up later as a bouncy deck surface or high and low spots once decking goes down.
The Technique
- Before setting them, sight down each joist to find its crown, and lay them out crown-up as usual.
- Line several joists up side by side on sawhorses or the deck framing, and clamp them together at both ends so the top edges are held in the same plane.
- Run a hand or power planer along the clamped-together top edges, taking down any high spots until every joist top is level with its neighbors.
- Release the clamps and install the joists as planned — crown still facing up, but now with matched, level tops.
Pro tip: Bar clamps long enough to span several joists at once make this fast — you don't need the most expensive brand, just something that reaches the full width of the stack so nothing shifts while you plane.
DIYsolvr helps you find the best DIY videos. Browse all 526 techniques