Start a Plunge Cut on the Safe Quadrant of the Chainsaw Bar Tip

Kickback comes from the upper quadrant of the bar nose, so a plunge cut is entered on the lower quadrant. Score a shallow groove with the bottom of the bar first to give the chain a track, then push through at a slight downward angle.

plunge cut chainsaw, bore cut, chainsaw kickback zone, which part of the bar kicks back, cut into the middle of a log, chainsaw nose danger

advanced Tools: chainsaw Added Aug 24, 2026
Warning: A plunge cut deliberately puts the nose of the bar into the wood, which is the one thing every chainsaw course tells you not to do. Kickback from a bar nose throws the saw up and back toward your head and shoulders faster than you can react to it. This is not a cut to learn from a written description — get hands-on instruction, and don't attempt it with a saw that has no chain brake.

The Problem

Some cuts have to start in the middle of the wood rather than at an edge: relieving a bind, cutting a hinge on a felling cut, working in a confined space where there's no face to enter from. That means burying the nose of the bar in the timber, and the nose is where kickback comes from.

The Technique

The bar nose is not uniformly dangerous. Think of the tip as a clock face: the upper quadrant is the kickback zone, where the chain is travelling up and back out of the cut and can catch and throw the saw. The lower quadrant is pulling down and into the cut instead.

That distinction is the whole technique.

  1. Score a shallow groove first using the bottom of the bar, in line with the cut you want to make. This gives the chain a track to sit in so it can't skate across the surface when the nose goes in.
  2. Enter with the lower quadrant of the nose, in that groove, pushing through at a slight downward angle.
  3. Once the bar is buried and through, cut down through the bottom of the opening.
  4. Finish by cutting upward to complete the cut.

Don't skip the scoring step. A nose set against unmarked bark has nothing to hold it in line, so it skates across the surface — and a nose that skates lands wherever it stops, which includes the upper quadrant.

Safety note: Full PPE, both hands on the saw with thumbs wrapped, and a saw with a working chain brake. A sharp chain matters more here than on any other cut — a dull chain grabs rather than cuts, and grabbing at the nose is exactly the event you're avoiding. Stand out of the plane of the bar, keep your face away from the line the saw would travel, and stop the cut and reset rather than fighting the saw if it starts to skate.

DIYsolvr helps you find the best DIY videos. Browse all 609 techniques