Pest Control: Prevent Mice From Dragging Your Snap Traps Off by Screwing Them to a Board

Screw your wooden snap traps down to a single board. The board also lets you lift them out without risking your fingers.

trap disappeared overnight, catch more than one mouse at a time, mouse trap behind the fridge, rodent trap placement, trap moved by itself

beginner Tools: drill Added Nov 2, 2026

The Problem

A mouse caught by a foot or tail can drag the whole trap, which can end up somewhere you cannot get at.

Loose traps are also awkward to work with. Every trap has to be placed individually, checked individually, and picked up individually.

If you have mice that can lick off the bait without springing the trap, you no longer have to pick up an unsprung trap and risk your fingers.

The Technique

  1. Lay a wooden snap trap flat on an offcut of board.
  2. Drive one screw through the trap's wooden base into the board.
  3. Add as many traps to the same board as you want, spacing them at least a few inches apart. They can face in either direction.
  4. Bait and set the traps.
  5. Carry the board to where you want it and set it down.

What You'll Need

Wooden snap traps, a flat offcut of board big enough for the number you want to run, and one screw per trap. Any scrap of ply or softwood works, so long as it sits flat and is heavy enough not to slide.

Pro tip: Retrieval is the part this changes most. You lift the board by an end instead of reaching for a sprung trap, so you can take several catches out in one trip and re-bait away from where the mice are travelling.
Safety note: Drive the screws before you bait or set anything, so you are never working over an armed trap. Wear disposable gloves to handle a catch, and treat the board and traps as contaminated afterwards — rodent urine and droppings carry disease, and so does anything they have been sitting on.

DIYsolvr helps you find the best DIY videos. Browse all 609 techniques