Wiring
Snug Up a Recessed Outlet With a Spacer Nut on the Mounting Screw
Threading a nut onto the mounting screw as a spacer to snug up a loose or recessed outlet.
@biewer_remodeling_ · Instagram
Technique: The Brass Tab on a Switched Outlet
Swapping every receptacle and switch in a house is one of the most common jobs a homeowner takes on — it costs little, it modernises every room at once, and it's an easy win before selling. The method is to work outlet by outlet, copying each set of wires onto the new device.
Somewhere in the house there's usually a half-switched receptacle: the top half live all the time, the bottom half controlled by a wall switch, so a lamp turns on from the door. From the front it looks identical to every other outlet. The difference is inside — on the old device, the small brass tab joining the two hot-side screws has been snapped off, separating the two halves.
Look at the tab on every device you remove, before it goes in the bin.
Miss it and the result depends on how the circuit was built:
Electrical, plumbing, and structural work may be regulated where you live — check local code before you start, and note that a permit may be required. More in our disclaimer.
DIYsolvr helps you find the best DIY videos. Browse all 609 techniques