Paint a Room Faster by Rolling Before You Cut In

The Problem

If you cut in a whole room before you pick up the roller, you brush a band of wall the roller would have covered anyway.

The Techniques

Roll before you cut in

  1. On the primer coat and the first coat, roll first. Take the roller as close to each edge, corner and ceiling line as it will go.
  2. Then come back with a brush and fill in the couple of inches the roller couldn't reach.

Over a whole room or house, the creator puts the saving at hours.

Wet the brush before it touches the paint

  1. Run the brush under water, or dip it in a bucket of water.
  2. Flick the water out so the bristles are damp, not dripping.
  3. Load it with paint as normal.

Paint grips damp bristles less, so cleanup takes about half the time. It also keeps paint from creeping up and caking around the ferrule. Do this with water-based paint only; don't put water in a brush you're about to load with oil.

DIYsolvr helps you find the best DIY videos. Browse all 609 techniques