Stop a Ratchet Strap Tail Flapping by Rolling It Up and Locking the Roll

The Problem

Straps come long enough for the biggest load they will ever see, so most jobs leave two or three feet of webbing hanging off the buckle. At speed that tail chafes paint, works into a wheel or a drive chain, and gets drawn into the ratchet mechanism.

Whatever holds it has to come undone again in a parking lot with cold hands, and a knot in webbing has to be picked apart.

The Technique

  1. Roll the loose webbing toward the buckle, winding it into a flat coil in your hand. Stop while you still have a short tail left loose — a foot or so is plenty.
  2. Keep the coil slightly open. Don't wind it so tight that there is no gap through the middle — the tail goes through that gap next.
  3. Pass the loose tail through the middle of the coil, from one side to the other. Leave it slack rather than pulling it down — the slack forms a loop sitting against the roll.
  4. Pass the tail back over the outside of the coil and through that loop, then pull it down. This cinches the coil shut and traps the tail under its own turn.

You end up with a fist-sized roll at the buckle instead of three feet of webbing. When you pull the tail back out of its turn, the whole thing unrolls in one motion.

Pro tip: Chaining the tail into itself leaves a long braid rather than a roll and can be done one-handed on a strap already under load. The roll is faster and tidier; the chain is easier on a short tail or in a tight space where you can't get a hand behind the buckle.

DIYsolvr helps you find the best DIY videos. Browse all 609 techniques