Hang a Garden Hose on a Shed Wall With a Spare Hinge and a Bungee Cord

The Problem

A garden hose left on the ground gets driven over, kinked, and walked through, and coiling it onto a nail bends the hose over a hard point that eventually splits. A proper hose reel or wall hanger costs money and takes a trip to the store, and the whole job is holding up maybe twenty pounds of coiled rubber.

The Technique

Most people have a single orphan hinge in a drawer — left over from a door, a gate, or a flat-pack — with no matching partner and no obvious use.

  1. Screw one leaf of the hinge flat to the wall of the shed, carport post, or fence rail, so the other leaf can swing out and stand proud of the surface.
  2. Hook one end of a bungee cord over the standing leaf.
  3. Coil the hose, pass the bungee around the coil, and hook the other end back onto the same leaf.

The cord takes the load and spreads it around the coil instead of concentrating it on one point, and the hinge gives the bungee a fixed steel hook to grab that a screw head or a nail can't do as securely.

Pro tip: Drive the screws into a stud, a post, or the shed's framing rather than into siding or a thin shed panel alone. The hinge is small enough that it looks like it can go anywhere, but a wet coiled hose is heavy, and the failure is the screws pulling out of the sheet material rather than anything to do with the hinge.

DIYsolvr helps you find the best DIY videos. Browse all 609 techniques