Clear Sawdust Off Your Work With Your Drill's Own Fan

The Problem

If you blow sawdust off a mark or out of a fresh hole with your mouth, some of it ends up in your face.

The Technique

A drill already has a fan in it: it cools the motor by pulling air in through one set of vents in the housing and pushing it out through another.

  1. Squeeze the trigger and hold your hand near the vents to find the set that blows out.
  2. Hold the drill so those vents point at the sawdust, a few inches away.
  3. Run the trigger. The bit can stay in the chuck, but keep it clear of the work and your other hand.
Safety note: Keep your face away from both sets of vents. If you aim the intake side at the sawdust, the drill pulls the dust in and can blow it back out toward you. Wear eye protection.

DIYsolvr helps you find the best DIY videos. Browse all 609 techniques