The Problem
A recessed light needs a hole the size of its trim and a void deep enough for its body, and you find out whether you have either by cutting a hole and looking. When you cut into a joist, the hole is in the wrong place and has to be patched — a plasterboard patch in a ceiling, sanded and painted to disappear, for a light that ends up four inches to the left anyway.
Pipework, ducting and cable trays are worse than joists, because a stud finder reads the joists and says nothing about the rest.
The Technique
- Cut a piece of stiff wire to the length of the light fitting's body — the part that has to sit up inside the ceiling.
- Drill a small pilot hole at the center of where the light is going.
- Feed the wire up through the pilot hole until the bend or your fingers reach the plasterboard.
- Swirl it in a full circle. Free rotation means the fitting's diameter is clear of obstruction and the void is at least as deep as the fitting is long, because the wire is cut to that length. If it catches, something is in the way.
- Move and re-pilot until a probe comes back clear, then cut the hole.
A pilot hole in the wrong place takes filler and ten minutes.
Pro tip: Fit a dust catcher to the hole saw for the real cut. A ceiling cut drops its dust straight down into the room, onto whatever flooring is underneath it.
Safety note: Isolate the lighting circuit at the breaker before any of this. The probe tells you something is in the way, not what it is, and the most likely thing above a ceiling you are putting a light into is cable. Feed the wire gently and stop at the first resistance — never push past it to find out what it was. Confirm the circuit is dead with a voltage tester rather than trusting the switch.
Electrical, plumbing, and structural work may be regulated where you live — check local code before you start, and note that a permit may be required. More in our disclaimer.