Turn a Stuck Shower Valve Bonnet Nut With a Coupling and a Pipe Stub

The Problem

If the bonnet nut on a shower valve will not move by hand, the instinct is to put tongue-and-groove pliers on it and squeeze. The jaws bear on two small areas of a thin brass nut, so it deforms before it turns. A nut that has gone out of round is harder to get off than one that was merely tight.

The Technique

  1. With the water off at the stops or the main, fit a two-inch rubber pipe coupling over the bonnet nut and tighten the hose clamp on that end down onto the nut.
  2. Push a stub of two-inch pipe into the free end of the coupling.
  3. Put your pliers on the pipe, not on the nut, and twist. The pipe gives you something to get a full grip on. The coupling carries that turn to the whole circumference of the nut.
  4. Once it breaks free, spin the nut off.
Pro tip: This is a second take on the rubber-coupling trick already on the site, with a clamp and a pipe stub added. Full contact around a round part beats point contact on two flats — the same reason a strap wrench turns an oil filter that pliers only dent.
Safety note: On an older valve, the supply connections behind it are soft copper. Breaking one turns a cartridge change into replacing the whole valve inside the wall. If the nut is not moving with the pipe handle, stop rather than pulling harder.

Electrical, plumbing, and structural work may be regulated where you live — check local code before you start, and note that a permit may be required. More in our disclaimer.

DIYsolvr helps you find the best DIY videos. Browse all 609 techniques